1mv, with right floating between +6mv and -10mv. Managed to get Center Voltage on Left to. Put pots back in position and fired it up. Took off DBT and plugged in to wall voltage. Shut it down marked the pots for adjusting the center voltage and bias then worked them out. The spkr outs were 175mv on the left and anywhee from 20mv to 300mv on the right. So I took some measurements on the speaker out's while the relay was merriliy clicking along. I put it on my DBT and brought it up and got no smoke. Opened it up and immediately saw that the Relay had been bypassed directly to the speaker switch, and one side of the Preout/main in had been bypassed. (at least all the feet are there and the bottom is intact. The guy drilled out the front panels to fit the switch! The Wood ends on the front fascia are gonna need replacing also. Looks like Danny yesterdays audio may have them all. So I'm gonna have to get the Front sub panel, Front panel and a new switch. Veneer is peeling(vinyl), and who ever had theis 1st put a 1/4 turn KEY SWITCH in for the power switch (key is one of those one for Vending Machines!WTF?) He knew it had problems when he got it.Ĭosmetically it looks as if it's been sitting in a shop. I've already talked with him about the 939's problems. Nothing that follows is a reflection on Ed. Thanks Ed.(That's as far as I'll go as to ID'ing the Gentleman unless he opens up here.). Received a somewhat rough SX-939 today in the mail from another AK'er as a "gift".
0 Comments
Leave a Reply. |